Detailed Computer Display Board Repair Instructions

$45.00
includes shipping and handling

Ready to order or want more information?
Click here to contact me.

I do have a very easy fix for your bad or dimming Two Button F250 / 350 Super Duty Computer Board with great results, review my write up below to help you decide if the instructions will help you save the expense of a new board.

Ford had quality problems with about eight out of ten two button boards in the early years 1999 to 2003 going dead, it is a common and a very easy to fix problem. My detailed instructions with pictures show you how to remove the console cover plate, remove the screws holding the board in place and how to find and fix the problem with close up  inlarged pictures. Repair work can be done with one cheap simple $8.00 Radio Shack tool, 98% of the time no parts are needed but I do include a couple parts if by chance your board falls into that 2%. One way to help you decide if these instructions will help with your repair is to check it for the following, if your board is completely DEAD or comes ON and OFF sometimes  with a tap or bump, if the board goes DIM  and then get BRIGHT or stay DIM  this IS most likely the easy to fix problem 99.8% of the time. 

If the board lights up and works but some screens display and some do not, or the readings on the screen are not reading correct it is more than likely NOT the easy fix problem. The boards from Ford cost $300.00 and are very hard to find used and most used boards will developed this same problem.  I have sold many board repair instructions with great results. I only sell them on this website and can assure you that you cannot lose, their is no risk  for $45.00  If for any reason  you don't like the instructions, they don't work, or you think you can not do the repair I will credit the $ 45.00 to a new board from this site.

Hundreds of customers have been buying these instructions with great results. They always work the repair corrects the factory quality problem to new condition. Many people think the black round burn marks on the LED screen in one corner or more means the board is bad (NOT TRUE) New Boards have these same spots during the building process. Look at a new board picture on my website, it also has the same burn spots..

My instructions work, I have almost a 100% success rate but you never know with electronics.

I give you two ways to do the repair depending on your skill level, it does take a lot of skill to do the repair but once you know the problem you can always ask a friend to help.

I do sell new Ford OEM boards at the best price you will find, if my instructions do not work or you change your mind I will credit you the $45.00 to the purchase of a new board from my website.

OPTIONS:

1. Buy the instructions and if they work for you and you save some big bucks.
2. Buy the instructions read them and if you decide not to do the repair I will credit you $45.00 towards my new      board.
3. Buy a New Ford Board from me and trade in your old board for a $20.00 credit  (bad board being traded in for the $20.00 credit must comply to Note (A)  listed below.

 Note: ( A )  I can only credit you the $20.00 for your old board after I receive the board and make sure no one tried to do a repair or modify it.

            How can you lose?